Nidec Copal JP-30 Single-turn Cerment Potentiometer

Nidec Copal JP-30 Single-turn The use of cermet resistors allows for a low price. The degradation is theoretically infinitely small. Cermet types are single-turn for use in servo drives and for settings.

Nidec Copal JP-30 Single-turn Cement Potentiometer

Potentiometers are displacement sensors that produce electrical output (voltage) in proportion to the mechanical displacement. They are basically composed of a resistor and a wiper (brush), with the mechanical displacement of the resistor relative to the wiper being accurately converted into an electrical voltage output. A voltage is applied to both ends of the resistor, and the wiper is moved. The displacement is measured by the voltage between one terminal of the resistor and the wiper. Looking at the component structurally, we can see the following: (Fig. 1) Further, the following formulas apply to the voltage output



Nidec Potentiometer

Model of potentiometer

Wirewound Type

Precision wire winding technology has been used to achieve low noise and long life. Wirewound types include the single-turn J series for use in servo drives and the multiturn M series for use in settings.

Conductive Plastic Type

Special film resistors and original contact construction provide long life, with degradation that is theoretically infinitely small. Conductive plastic types include single-turn types and linear types, both for use in servo drives.

Cement Type

The use of cermet resistors allows for low prices. The degradation is theoretically infinitely small. Cermet types are single-turn for use in servo drives and for settings.

Optical Contactless Type

Contactless configuration offers a much longer life and lower noise compared with the conventional contact method.



  • Cost effective (In house comparison)
  • High resoluiion (Essentially infinite)
  • RoHS compliant


Nidec Copal Electronics’ products are widely used in various applications, mainly in industry.

  • Vehicle, Construction machine
  • Medical equipment
  • Analytical / Messuring equipment
  • FA equipment
  • Residential facility, Security
  • Social infrastructure, Commercial tool, etc.


Resistance torelance ± 2%
Resolution Essentially infinite
Independent linearity ± 0.
Effective electrical angle 300° ± 1°
Mechanical angle 360° continuous
Power rating (at 40 °C) 1.5W
Dielectric strength 1000 Vrms 1 min
Insulation resistance 1000 MΩ minimum(at DC500 V)
Rotational torque 2.94 {30} mN·m {gf·cm} maximum
Peak noise 2 % or 100 Ω, whichever is greater
Temp. coefficient of resistance ± 150 10-6/°C
Operating temp. range − 55 ~ 85°C
Maximum rotational speed 150 r/min
Rotational life 3 million revolution
Net weight Approx. 26g
Strength of tighten screw 0.98 N·m {10 kgf·cm} maximum
  • Perform soldering of the terminals at 380 °C for no more three seconds, and avoid applying excess heat. Also, avoid applying outside force to the terminals.
    In case of using multiturn potentiometers, when rotating the shaft to the mechanical limit, apply torque below the strength of the stopper. Also, give due consideration to thrust and radial loading.

Resistance Values, Rate voltage and Rated Current

Nominal resistance value(Ω) Rated voltage(V) Rated current(mA)
500 27.3 54.7
1 k 38.7 38.7
2 k 54.7 27.3
5 k 86.6 17.3
10k 122 12.2
20 k 173 8.66
50 k 273 5.47
100 k 387 3.87


Datasheet: Nidec Copal JP-30 Single-turn Cerment Potentiometer

Shopping Cart